Key, D.L.Siguba, Maxhobandile2022-03-102024-05-092022-03-102024-05-092005https://hdl.handle.net/10566/14585>Magister Scientiae - MScA comparative study of electrolysers using different anodic materials for the electrolysis of brine (sodium chloride) for the production of sodium hypochlorite as a source of A comparative study of electrolysers using different anodic materials for the electrolysis of brine (sodium chloride) for the production of sodium hypochlorite as a source of available chlorine for disinfection of rural water supplies has been undertaken. The electrolyser design used was tubular in form, having two chambers i.e. anode inside and cathode outside, separated by a tubular inorganic ceramic membrane. The anode was made of titanium rod coated with a thin layer of platinum and a further coat of metal oxide. The cathode was made of stainless steel wire. available chlorine for disinfection of rural water supplies has been undertaken. The electrolyser design used was tubular in form, having two chambers i.e. anode inside and cathode outside, separated by a tubular inorganic ceramic membrane. The anode was made of titanium rod coated with a thin layer of platinum and a further coat of metal oxide. The cathode was made of stainless steel wire. An assessment of these electrolysers was undertaken by studying the effects of some variable parameters i.e. current, voltage and sodium chloride concentration. The flow rate was kept unchanged at 50ml/h anolyte and 140ml/h catholyte since it was found to be optimum flow rate for chlorine generation. Figures of merit of the electrolysers were calculated on the basis of three sets of measurements. Analytical methods used for the determination of sodium hypochlorite concentration were iodometric and N, N-Diethyl-p- Phenylenediamine (DPD) titration methods. The DPD titration method was used to determine the chlorine concentration of less than 1mg/L, while the iodometric titration method was used to determine chlorine concentration of ImgIL and above. Sodium chlorate present in the hypochlorite solution was also determined using a spectrophotometric method. The cobalt oxide electrolyser has been shown to be superior as compared to the ruthenium dioxide and manganese dioxide electrolysers in terms of hypochlorite generation. Sodium chlorate was present but at concentration levels not hazardous for use in dosing water for drinking purposes. Analysis of hydroxyl radicals was undertaken since there were claims that these are produced during brine electrolysis. Hydroxyl radical analysis was not successful, since sodium hypochlorite and hypochlorous acid interfere using the analytical method described in this study.enAcid constantCurrent efficiencyDepartment of Water Affairs and Forestry (DWAF)Dimensionally stable anodes (DSA)Dimethyl sulfoxide (DMSO)Cobalt oxide titanium anodes (COTA)Ferrous Ammonium Sulphate (FAS)University of the Western Cape